By material


Quartz glass (glass / abrasive cutting) φ800mm×70t

Cutting (high pressure abrasive) Since the processing stress is low, glass can be processed without breaking. A feature of the water jet is that it can process thin to thick materials.

Urethane foam (foam plastic / hydro cutting)

Foam urethane 1,000 × 1,000 × 80t [mm] Resin-based foams, fibers, paper, etc. can be processed only with water.High pressure hydro type is also used for trimming automotive interior materials and cutting disposable diapers. (The unevenness of the product in the photo is not due to water jet processing, but was taken up so that
・・・Learn more

CFRP (Reinforced Plastic / Abrasive Cutting) φ290mm×3t

CFRP (carbon fiber reinforced plastic) Thickness 3.0t x Outer diameter 290, 1-φ50 Center hole, 6-φ50 (PCDφ150) [mm] Lightweight and strong CFRP helps to reduce the weight of components.It is a material with excellent wear resistance, electrical conductivity and design. Water jet machining is suitable for CFRP, which is difficult to cut.Can be cut without burami
・・・Learn more

Diamond wheel grooving

Diamond wheel: Diamond layer 8t + Aluminum pedestal 40t x φ450 Slit 3 width x 8 depth [mm], 13-circumference line, 16-radiation Cutting performance is improved by inserting grooves in the diamond layer.

Aluminum (A5052)

Aluminum (A5052) Plate thickness 10t x 115mm x 250 half flange shape (flange width 12mm)  13-φ6mm Orthodox water jet cutting and drilling. There is no heat effect, no deformation, and no discoloration.The cutting width is about 1mm, and it can be arranged without gaps even when many pieces are taken, so there is no waste
・・・Learn more

Silicone sponge rubber

Silicone sponge rubber Silicon sponge rubber with a plate thickness of 2mm, outer size is □ 55mm × 91mm business card size with R5 at one corner. The square hole in the middle is 30mm × 30mm with R3 at two corners.There are 3 round holes with 3 φ3.5mm and 5 φ1.0mm. Since the processing
・・・Learn more

Crystallized glass wall material

Crystallized glass wall (Neoparier) Original plate size 900 × 900mm × 20mm thickness Product size About L1750 x H700mm Back size base plate x 4 The product is in two colors, and the parts are cut in one handrail hole at 14 external cuts, the back is also in two colors, a cut for inlaying
・・・Learn more

An object with aluminum in acrylic (Plastic / nonferrous metal / Abrasive cutting)

Base: Acrylic 5.0t × 49 × 65, Lattice 15 × 15, Slit width 1.0 [mm] Piece: Aluminum (A5052) 10.0t × 15 × 15 [mm] With water jet processing, there is little heat effect or processing stress during processing, so distortion does not occur even when the aspect ratio is 5 times.